Using The Heater - HOMCOM KPT-2000 5158L Manual Del Usuario

25. The use of attachments or accessories not recommended or sold by the product
distributor may cause personal or property hazards or injuries.
26. This product is intended for normal domestic/household use only.
Use this heater as described in this manual. Any other uses, not recommended by
the manufacturer, may cause fire, electric shock, or injury to persons and may
void the warranty.

USING THE HEATER

1. Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label of the unit.
2. When plugged in, turn on the Main power switch
3.When in Standby mode, only press
touch, and the LED display shows the room temperature. Press
rest of the control panel.
(a) Low Power: About 1000W (Press
(b) High Power: About 2000W ( Press
(c)TIMER: Press this button
will turn itself off (From 0 hour -8hours)
(d) + , - : adjust room temperature .Temperature setting from 10-49℃. Press "
to increase the desired temperature and "
When the room temperature lower 4 ℃ than the settled temperature of unit, it's high
power working, lower 2℃, lower power working, if room temperature reach the
setting temperature, the heating stop, fan is permanently on till room temperature
lower than the setting temperature 2℃, the unit automatically return to lower power
heating, if room temperature lower 4 ℃ , higher power heating, it's automatically
return to heating.
(e) Swing : Press
(f) Press to turn off the heater, the unit will keep working 30 seconds of cool air
after turn off it . this design can protect item use longer.
Warning:
1. Before removing the plug from the socket, switching off and better work for 30-
60 second for cool down in condition that protecting inner parts.
2. Remote control Install lithium battery, battery model No. CR2025
repeatedly to set a period after which the heater
to activate swing. Press it again to cancel.
on the control panel will respond to your
to switch it, one
to switch it, two
" to decrease the desired temperature.
3
at the back of the unit.
to access the
light on )
light on together )
EN
"