Climbing Technology BE UP Manual Del Usuario página 6

10
BELAYING OF 1 OR 2 SECONDS
INSTALLATION / SETUP
10.1 10.2
SETUP SETUP
Connect a wide base HMS Clip the belay karabiner
karabiner to the top of the an- through the rope and the
chor and insert it in the Be Up. connection cable as shown.
Close the karabiner gate!
Place a loop of rope through
the C part of the Be Up.
Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY
This mode allows the belaying of one or two seconds simultaneously and independently.
After the setup and before the belaying you must test the system as shown in the fi gure 10.3.
10.3
TESTING
Pull the rope down on the clim-
ber's side, to make sure the sel-
f-locking system works.
www.climbingtechnology.com
10.4
NO!
10.6 10.7
NO!
IST12-2D657CT_rev.4 10-21
10.5
10.8
FRICTION FRICTION
NO!
6/28