Hilti BX 3-22 Manual De Instrucciones Original página 22

Trouble or fault
The spring element is not
tensioned, status indicator
flashes green.
The fastener guide cannot be
pressed in and status indica-
tor shows blue.
The fastener guide cannot be
pressed in and status indica-
tor shows green.
There is a delay before the
spring mechanism is ten-
sioned, the status indicator
flashes blue and a signal tone
is emitted simultaneously; the
status indicator then lights
blue for 6 minutes.
The spring element is not re-
tensioned and status indica-
tor flashes yellow.
The spring element is not ten-
sioned and the status indica-
tor flashes red.
The spring element is not ten-
sioned and the status indica-
tor lights red.
The spring element is not ten-
sioned; no status indication.
The fastener guide is jammed
in the pressed-in state.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
16 English
Possible cause
The battery is empty.
The magazine is empty.
The nail pusher is jammed.
Nail jammed in the fastener guide.
The magazine is empty.
The fastening tool has overheated.
Battery temperature too high.
Battery temperature too low.
The fastener guide is not fitted
correctly.
System fault.
The battery is empty.
The battery is not fitted correctly.
Deep discharge protection is ac-
tive.
Dirt between the fastener guide
and the nosepiece.
Action to be taken
▶ Change the battery.
▶ For magazine operation, load
the magazine. → page 11
▶ Remove the nail strips from
the magazine and clean the
magazine.
▶ Release the jammed nail.
→ page 14
▶ For magazine operation, load
the magazine. → page 11
▶ Allow the fastening tool to cool
down.
▶ Allow the battery to cool down.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Insert the fastener guide.
→ page 11
▶ Contact Hilti Service.
▶ Change the battery.
▶ Remove and then correctly
reinsert the battery. → page 10
▶ Remove and then reinsert the
battery.
▶ Clean the inside of the nose-
piece. → page 15
2268214
*2268214*