Uline H-4407 Manual Del Usuario página 3

Figure 7
4b. Using other end of assembled X-brace from the
right frame, attach to the bottom hole and third
hole up from the bottom on the middle frame. With
the second assembled X-brace, attach to the
middle frame using the same bottom hole and
third hole up from the bottom (the brace ends
overlap). Only one notched end may be on the
bottom hole and one on the third hole up from the
bottom. Hand tighten. (See Figure 9)
Figure 9
4c. Attach assembled X-brace to the left frame using
the other end of assembled X-brace. Hand tighten.
NOTE: Not all holes on the frame will be used.
4.
PAGE 3 OF 15
ASSEMBLY CONTINUED
Figure 8
5. At this point frame is able to stand up on its own.
Make sure the frame is straight, square and level.
Tighten all 3/8" bolt connections with socket wrench.
(See Figure 10)
Figure 10
6. Attach the spacers to the back of the second seat
frame using a 3/8" bolt and flange nut. Tighten with
a 3/8" socket. (See Figures 11 and 12)
Figure 11
Spacer
Figure 12
Spacer
0122 IH-4407