How To Use The Buttons - Ferroli DIAMANT Serie Manual De Instrucciones

DIAMANT

2.4 HOW TO USE THE BUTTONS

By pressing the "MODE" button ("fig. 5 -") it is possible to select
the operating modes (Fig. 3) you prefer, choosing between the
following ones: AUTO - COOL - DRY - HEAT - FAN.
1. AUTO Mode- Automatic: this function is selected by pressing the "MODE" button until the relative Symbol appears on the
display. The conditioner automatically sets the suitable operating mode (COOL, DRY, HEAT, FAN) depending on room tempera-
ture. The temperature can be set within a range of 17°C ~ 30°C in 1°C increments.
2. COOL Mode- Cooling: this function is selected by pressing the "MODE" button until the relative Symbol appears on the display.
The unit begins to operate if the set temperature is lower than that of the room. The temperature can be set within a range of
17°C ~ 30°C in 1°C increments. In this operation mode, it is possible to set fan speed (high-medium-low-auto) by pushing the
FAN button.
3. DRY Mode - Dehumidifying: this function is selected by pressing the "MODE" button until the relative Symbol appears on the
display. The unit will begin to operate in the cooling mode, and will quickly reach the required ambient temperature. Condensation
may form on the delivery port if the "DRY" function is used for a long period of time (the fan seed isn't adjustable). The tempera-
ture can be set within a range of 17°C ~ 30°C in 1°C increments.
4. HEAT Mode- Heating: this function is selected by pressing the "MODE" button until the relative Symbol appears on the display.
The unit begins to operate if the set temperature is higher than that of the room. The temperature can be set within a range of
17°C ~ 30°C in 1°C increments. In this operation mode, it is possible to set fan speed (high-medium-low-auto) by pushing the
FAN button.
5. FAN Mode- Ventilation: this function is selected by pressing the "MODE" button until the relative Symbol appears on the display
and the unit get the air automatically circulating in the room. When operating in ventilation alone can not set a value for set point.
Cod. 3QE46160 - Rev. 00 - 11/2019
fig. 5 -
EN
25