Indoor Unit Display - Ferroli DIAMANT Serie Manual De Instrucciones

INDOOR UNIT DISPLAY

The meaning of the codes shown on the display of the indoor unit is described below ("fig. 7 -").
1. TEMPERATURE
In normal operating conditions, the display shows the temperature setpoint.
2. ERROR
In case of error, the display shows an error code as indicated in the table "ERROR DISPLAY".
3. ECO FUNCTION
By activating the "ECO" function, the "88" symbol lights up gradually showing the letters "E- - C - - O", followed by the temperature
setpoint
4. TIMER ON/FUNCTION ACTIVATION
The display shows the text "ON" for 3 seconds when:
• a delayed start timer is activated ("TIMER ON")
• one of the following functions is activated: "SWING" or "TURBO"
5. TIMER OFF/FUNCTION DEACTIVATION
The display shows the text "OF" for 3 seconds when:
• a delayed shutdown timer is activated ("TIMER OFF")
• one of the following functions is deactivated: "SWING" or "TURBO"
6. DEFROST ACTIVATION
The display shows the text "dF" (defrost) when the outdoor unit performs a defrost cycle.
7. SELF CLEAN ACTIVATION
The display shows the text "SC" when the unit performs a battery drying cycle
8. PRE-HEATING FUNCTION ACTIVATION INDICATION
The display shows the text "cF" when the pre-heating function is active to avoid cold air flow. The function is only available in heating
mode.
9. WIFI ACTIVATION
The display shows the symbol shown in "fig. 7 -", detail 1, when the unit is regularly connected to the wireless network for remote
control.
10. REFRIGERANT LOSS
In "COOL" operating mode, the display shows the text "EC" if a refrigerant leak is detected.
11. ANTI-FREEZE MODE ACTIVATION
The display shows the text "FP" (frost protection) when the antifreeze function is activated, which allows to set a safety temperature
of 8 ° C in the room. The function is only available in heating mode.
12. CLEAN FILTER OR FILTER REPLACEMENT
After 240 hours of use, the display shows the text "CL" for 15 seconds, as a reminder to clean the air filters, then the warning disap-
pears.
After 2,880 hours of use, the display shows the text "nF" for 15 seconds, as a reminder to replace the air filters, then the warning
disappears.
To reset the reminder, press the "LED" button 4 times or press the emergency button 3 times. If the reminder is not reset, it will appear
again, as described above, when the unit is turned back on.
32
EN
fig. 15 -
Cod. 3QE46160 - Rev. 00 - 11/2019
DIAMANT