Safety And Pollution; General Considerations; Service And Spare Parts; Trouble Shooting - Ferroli DIAMANT Serie Manual De Instrucciones

DIAMANT

3. SAFETY AND POLLUTION

3.1 GENERAL CONSIDERATIONS

The machine has been designed to reduce risks to persons and to the environment in which it is installed, to the minimum. To eliminate
residual hazards, it is therefore advisable to become as familiar as possible with the machine in order to avoid accidents that could
cause injuries to persons and/or damage to the machine.
Consult the technical safety briefs available from coolant manufacturers for further information about the
characteristics of the cooling fluid.

4. SERVICE AND SPARE PARTS

Ask the dealer where the appliance was purchased for the address of our nearest Service center or look in the Yellow Pages under
the heading: "Air Conditioners" or "Boilers".

4.1 TROUBLE SHOOTING

The table below explains some of the faults that the electronic monitoring plant may detect and transmit to the user.
Issue
The unit does not start by pressing ON/OFF
button on the remote control
The indoor unit works properly while the
outdoor unit remanins off.
The unit works but does not cool.
The compressor operates for short periods
and stops for a few minutes.
Cause
No power
The unit has a overload protection functions.
The unit can be restared 3 minutes after
being switched off.
The outdoor unit is not powered
The unit lacks refrigerant. Potential solenoid
valve failure
Unit partially lacks refirgerant charge. The
outdoor unit heat exchanger is dirty.
Cod. 3QE46160 - Rev. 00 - 11/2019
Solution
Check that the power cord is properly
plugged in the mains socket. Check that there
is voltage in the mains socket. If the fault
persists, call service.
Wait 3 minutes, then restart the unit.
Call service
Call service
Call service. Clean the outdoor unit heat
exchanger as indicated in the section "Clea-
ning the outdoor unit" of the present manual.
EN
35