Briggs & Stratton SNAPPER PRO S120B2561 Manual Del Operador página 14

H
I
J
K
L
M
Deck Lift Pedal, Cutting Height Adjustment Pin & Deck
Lift Lock Lever: The deck lift pedal (A, Figure 6), the cutting
height adjustment pin (B), and the deck lift lock lever (C) are
used together to control the cutting height of the mower deck.
See Cutting Height Adjustment for instructions on using these
controls.
6
Cutting Height Adjustment
Storage Hole for Cutting Height Adjustment Pin
Deck Lift Lock Lever
Parking Brake: Pull the parking brake lever up and
back to engage the parking brake. Move the lever fully
forward and down to disengage the parking brake.
Note: To start the unit the parking brake must be engaged.
Engaging the parking brake locks the ground speed control
levers in the NEUTRAL position. The parking brake must be
disengaged before moving the ground speed control levers
out of the NEUTRAL position.
DISENGAGE: Releases the parking brake.
14
Fuel Tank Cap
Fuel Level Gauge
Seat Adjustment Lever
Removable Floor Plate
Transmission Release Levers (One
per transmission)
Transmission Oil Fill / Tanks (One
per transmission)
ENGAGE: Locks the parking brake.
Ground Speed Control Levers: These levers control the
ground speed and direction of the rider. The left lever controls
the left rear drive wheel and the right lever controls the right
rear drive wheel.
7
FORWARD
NEUTRAL
REVERSE
N/A NEUTRAL LOCKOUT POSITION
The parking brake must be disengaged before attempting to
move the ground speed control levers from the NEUTRAL
position.
Moving a lever forward (A) from the NEUTRAL position (B)
increases the FORWARD speed of the associated wheel, and
pulling back (C) on a lever increases the REVERSE speed.
Moving a levers outwards (D) from the NEUTRAL position
locks the levers in the NEUTRAL LOCKOUT position.
Note: The further a lever is moved away from the neutral
position the faster the drive wheel will turn.
See the Zero-Turn Driving Practice section for steering
instructions.
Retractable Seat Belt: The seat belt is used to secure the
operator to the seat.
(Specific to models with a rigid Roll Bar):
The seat belt should always be worn when using this
equipment with a Roll Bar.
(Specific to models with a folding Roll Bar):
The seat belt should always be worn when the Roll Bar is in
the raised position. The seat belt should never be worn when
the Roll Bar is in the down position.
SnapperPro.com