Cleaning And Maintenance - Frigidaire DFN39 Manual De Instrucciones

Unplug the plug before performing this
operation.
Never clean your refrigerator
with cleaning agents such
as alcohol, kerosene,
gasoline, bleach, solvents,
acids, vinegar, abrasive or
other chemicals not recommended in this
manual.
Always unplug the refrigerator before
performing this operation, taking care not
to touch the condenser and compressor;
they can be hot.
Do not pour water directly into or out of the
refrigerator.
Inside cleaning
To clean the innner parts of the refrigerator, use
only a cloth moistened with a solution of water
and sodium bicarbonate (dilute 1 tablespoon
of bicarbonate for 1 liter of water).
Never use metal scrapers, sharp objects,
brushes, abrasive or alkaline cleaners to
cleaning of plastic surfaces inside your
refrigerator.
Outside cleaning
To easily clean the outside of your refrigerator,
use a solution of warm water with mild soap
and then dry it thoroughly with a clean cloth.
Every six months clean the condenser on
the back of the refrigerator using a vacuum
cleaner or a feather duster.
Accumulated dust avoids the correct operation
of the condenser, affecting the performance of
the refrigerator and leading to a higher energy
consumption.
32
All manuals and user guides at all-guides.com

Cleaning and maintenance

Cleaning the door seals
Clean the seals carefully with a soft, damp
cloth. The seals are not removable. After
cleaning, dry them being careful not to
damage them.
Water collector
Your refrigerator has a water collector located
on its back. Its function is to eliminate water
from the automatic defrost by evaporation.
The cleaning of the collector is not necessary
for the operation of the refrigerator. Avoid
contact with this refrigerator area.
LED Lamp Replacement
To replace the lamp of your refrigerator,
proceed as follows:
1. Turn the refrigerator off by unplugging the
power cord plug from the outlet.
2. Open the lamp cover by
pressing a side and pulling
the other side forward (A).
3. Replace the burnt lamp
for another of the same
size, maximum voltage and
power of 1,6W.
4. Replace the lamp, first
fitting the upper pins of
the plastic cover (B) and
then push the bottom end
(C) against the refrigerator
bottom part until it locks
into its original position.
5. Connect the power cord plug into the outlet.
Attention: Use just LED lamp
with the same specification on this
product. Incandescent lamp can not
be used.
A
B
B
C