PORSCHE DESIGN 911 Manual Del Usuario página 13

Problem Possible causes
No sound, or only 1. There is no connection between the 911 Speaker
distorted sound, through and your source device.
Bluetooth ®
2. Your source device is paired, but not connected.
wireless technology.
3. Your source device is connected.
4. You are outside the
911 Speaker's maximum reach [ max. 10 m ].
The Bluetooth ® 1. The 911 Speaker switched itself off because it
had not played any music for five minutes [ battery
connection between your
operation ] or for 60 minutes [ mains operation ].
source device and
911 Speaker was
2. You placed your already connected NFC-compatible
unexpectedly
source device close to the 'Centerpad'.
disconnected.
3. You selected the AUX input on your 911 Speaker.
Solution
1. Connect your source device as described.
2. The source device did not automatically connect and needs
to be manually connected.
3.1. Make sure that there are no sources of interference
[ e. g., a W-LAN router ] in the direct proximity of the
911 Speaker or source device.
3.2. It is often not possible to connect the 911 Speaker with a
mobile end device via simultaneous W-LAN and Bluetooth ®
connections without experiencing interference. Deactivate
W-LAN on your source device.
4. Reduce the distance between the 911 Speaker and your source
device.
1. To prevent the 911 Speaker from switching itself off
automatically, lower the volume of your source device to a
minimum [ mute ].
2. If you place an already connected NFC-compatible source device
close to the 'Centerpad', the Bluetooth ® connection will be cut
off again. To re-establish the connection, place the source
device close to the 'Centerpad' again.
3. Select the Bluetooth ® input and wait until the
911 Speaker connects.
Problem Possible causes
True Wireless Pairing 1. The pairing process can fail if a source device in
is not possible. connected with one of the
911 Speakers.
2. You did not press simultaneously on the Bluetooth
button and the corresponding volume button
[ + or – ].
3. Two source devices are connected with one of the
911 Speakers.
4. The two 911 Speakers are too far apart.
5. You selected the AUX input on at least one of the
two 911 Speakers.
6. One of the two 911 Speakers is already connected
with another [ third ] 911 Speaker via True Wireless.
7. You entered the same key combination on both 911
speakers.
One or both of the As a rule, after the connection, 911 Speaker 1 emits
911 Speakers are not the left-hand music channel and 911 Speaker 2 the
playing the desired right-hand one.
channel [ l, R, l+R ].
[ EN ] The 911 Speaker
Solution
1. Remove all Bluetooth ® connections between source
device[ s ] and the 911 Speaker and repeat the
die True Wireless pairing procedure.
® 2. Press simultaneously on the Bluetooth ® button and the volume
button.
3. Remove the connection with at least one of the two source
devices.
4. Reduce the distance between the two 911 Speakers
to under 10 metres.
5. Select the Bluetooth ® input on both 911 Speakers before you
begin the procedure.
6. Remove the True Wireless connection between the two
911 Speakers as explained in the instructions. Start the
procedure with the two 911 Speakers in question, as explained
in the instructions.
7. Repeat the registration procedure as explained in the
instructions.
Change the True Wireless mode as explained in the instructions.
24 | 25