Party Mode - PORSCHE DESIGN 911 Manual Del Usuario

Party mode

To swap from stereo mode to party mode, press the Bluetooth ® button on 911 Speaker 1 multiple times for around three seconds, until you hear
the message 'Party mode'. Now press the Bluetooth ® button on 911 Speaker 2 multiple times for around three seconds, until you hear the message
'Party mode'. Both your 911 Speakers are now in party mode.
To set both 911 Speakers to party mode straight away, proceed as follows:
1. Switch on both 911 Speakers using the Power button .
[ the LED flashes or illuminates in blue ] for 911 Speaker 1.
2. Select the Bluetooth ® input
3. Simultaneously press on 911 Speaker 1's Bluetooth ® and volume buttons
'True Wireless pairing'.
4. The left-hand LED of the 911 Speaker 1 will flash in blue.
5. 911 Speaker 1 will emit an acoustic signal every five seconds.
6. Select the Bluetooth input [ the LED flashes or illuminates continuously in blue ] for 911 Speaker 2.
®
7. Simultaneously press on 911 Speaker 2's Bluetooth and volume buttons
®
'True Wireless pairing'.
8. 911 Speaker 2's right-hand LED, located above the keypad, will flash in blue.
9. When you hear the message 'Stereo mode left' from 911 Speaker 1 and 'Stereo mode right' from 911 Speaker 2, and when the
flashing LEDs above the keypads of 911 Speakers 1 and 2 light up continuously, the connection has been established.
10. Press the Bluetooth button on 911 Speaker 1 multiple times for around three seconds, until you hear the message 'Party mode'.
®
11. Press the Bluetooth button on 911 Speaker 2 multiple times for around three seconds, until you hear the message 'Party mode'.
®
for a short time; you will hear the message
for a short time; you will then hear the message
Please note: The devices will automatically save the last True Wireless status; this status can only be deleted by simultaneously pressing the
Bluetooth and Mute buttons . If the last True Wireless status remains saved, the devices will automatically link up the next time they are
®
switched on, provided they are within reach of each other.
AUX-IN True Wireless
The AUX-IN port can be used in True Wireless mode. For this, the AUX-IN port on the 911 Speaker to which the 3.5-mm audio jack cable is connected must
be selected. The second 911 Speaker remains set to Bluetooth ® input.
[ EN ] The 911 Speaker
16 | 17