Important safety instructions
CAUTION
Risk of electric shock
Do not open!
CAUTION:
To prevent fire and electric shocks, refrain from opening the device.
The device does not contain any parts to be maintained by the user.
Any maintenance and repair work is to be conducted by qualified
specialists [ service staff ] only.
Read and follow all instructions.
Keep these instructions in a safe place.
Observe all cautions and safety instructions.
Operate this device in temperate climates only [ not in tropical climates ].
Do not use the power cord over 2,000 m above sea level.
The power cord is for indoor use only. Do not use outdoors or in humid spaces.
To prevent the risk of fire or electric shock, do not expose the device to rain or moisture.
Do not operate this device in the proximity of water.
Do not allow liquid to drop or spray onto the device.
Strong temperature fluctuations can lead to condensation [ water droplets ] inside the device. Wait until the moisture
build up has evaporated [ at least 3 hours ] before switching the device on again.
Do not place objects containing liquid [ e. g., vases ] on top of the device.
Do not place the device close to open fire, e. g. burning candles.
Never place the device close to sources of heat, e. g. radiators, storage heaters, ovens or other devices [ including amplifiers ]
that emit heat.
Avoid direct sunlight.
Ensure that there is at least 5 cm of space surrounding the device.
To prevent electric shocks, only connect the plug-in power supply with plug sockets or extensions into which the pins can be fully inserted,
so as to avoid exposed pins.
Never touch the signal cable or the plug-in power supply with wet hands.
Do not step on or clamp the plug-in power supply, in particular not close to the plug, plug sockets or in the area at which the cable exits the device.
The plug-in power supply must always be freely accessible in order to be able to pull it out in emergencies.
In stormy weather or if the device is to remain unused for a longer period, disconnect the plug-in power supply from the mains.
To disconnect the device from the mains, pull the plug-in power supply out of the plug socket.
Always switch the device off before you plug or unplug any connecting cables.
Always pull on plugs, not on cables.
Mount the device according to the manufacturer's instructions.
Place the device in an horizontal position, standing it on the rubber-coated area so that the Porsche logo is on the top.
Do not place the device close to any edges [ table or shelf edges ] to prevent any knocks and shakes from causing it to fall down.
If necessary, secure the device to prevent it from falling.
Always ensure that the Speaker is placed on a level surface. The device must always be in an upright position.
[ EN ] The 911 Speaker
4 | 5