Operation Of The Device; Switch On And Off; Deep Discharge Protection; Control Led - VOSS.farming Sunny 200 Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 122
Make sure that the conductor material of your fence does not touch the ground, e.g. due to
sagging.
Only use fence posts with insulators to insulate the conductor material from the post and the
earth. In this way, you prevent voltage from being lost and ensure that the desired current
strength flows through the conductor material of your fence.
I nfo
It is not necessary that you build a closed fence. You can end the fence as you wish.
8

OPERATION OF THE DEVICE

8.1

SWITCH ON AND OFF

The VOSS.farming sunny200 has two switch-on options:
The energiser pulses at normal speed (every 1.5 sec.)
AUTO
When the battery voltage is less than 12 V, the energiser pulses at a speed of 3 sec.
The energiser pulses at normal speed during the day (every 1.5 sec.)
NIGHT
The energiser pulses at night with a speed of 3 sec.
When the battery voltage is less than 12 V, the energiser pulses at a speed of 3 sec.
To switch on the energiser, set the switch (1) to one of the two levels.
The LED (4) flashes green in time with the pulse.
N OT IC E
»
If the control LED does not light up, the device is switched off, the battery is
empty or there is a defect in the device.
»
If there is no pulse output and the control LED flashes very quickly, the battery
must be recharged. The deep discharge protection has been activated.
To switch off the energiser, set the switch (1) to OFF.
8.2

DEEP DISCHARGE PROTECTION

With the energiser, a deep discharge protection is set as soon as the battery falls below a certain
voltage. This protects the battery from damage. The energiser is still switched on in this battery
protection mode, but no more pulses are emitted. The battery must then be charged externally
with the supplied power adapter.
N OT IC E
During recharging, the device must not be connected to the electric fence.
8.3

CONTROL LED

The control LED (3) gives you information about the status of the battery.
When the battery is full, the device pulses at normal speed (every 1.5 sec.) and the LED lights
up at the same rate.
At medium battery voltage, the device only pulses every 3 sec. The "Eco mode" is switched on
and the LED continues to flash at the same rate as the current pulse. The battery should be
recharged (see section 10.1).
N OT IC E
Note that when the NIGHT mode is switched on, the energiser automatically
switches to "Eco mode" at night. If the energiser in NIGHT mode also uses "Eco
mode" during the day, the battery should be recharged (see section 10.1).
32
INSTRUCTION MANUAL VOSS.FARMING SUNNY 200
42082 - 01.2022 - V5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

42082

Tabla de contenido