How To Route Cables - Pioneer PDP-S20-LR Manual De Instrucciones

English
CONNECTION TO A PLASMA DISPLAY
1 Connecting the speaker cables
1 Switch off the power of the plasma display.
2 Connect the input terminals of the speaker system and
the speaker output terminals of the plasma display with
the accessory speaker cable. Make sure the positive (ª)
and negative (·) terminals match when connecting.
1. Push the lever, insert the cable into the hole, and release
the lever.
· terminal (black) ª terminal (red)
Black
To the· terminal
(Speaker input terminals of the speaker system)
2. For the output terminals on the plasma display, push the
lever, insert the cable into the hole, and release the lever.
ª · · ª
R L

2 How to route cables

Speed clamps are included with the plasma display for
tidying your cables and keeping extra cable length out of the
way.
Speaker cable
4
All manuals and user guides at all-guides.com
Input terminal of speaker
Red
To the ª terminal
Output terminal of plasma
display
Wiring clamp
÷ After connection to the terminals, pull lightly on the cable
to confirm that the tips of the cable are properly con-
nected to the terminals. An imperfect connection can
cause sound interruptions and noise.
÷ When cable cores stick out and ª and · lines are short-
circuited, an excessive load will be applied to the plasma
display and the operation will stop or trouble will be
caused.
÷ When the polarity is reversed for one speaker (left or right)
at the time of connection to the plasma display, the bass
reproduction will be reduced, the sound positioning will
be lost, and a correct stereo effect will not be obtained.
Speed clamps
Use the supplied wiring clamp to hide
the cables from view.
Speaker cable