Residual Risks; Electric Shock; Hot Surfaces; Putting Into Operation - GUTFELS 4020 Manual De Instrucciones

EN

8.4 Residual risks

Dangers can arise from the device if it is
used improperly or not as intended.
Residual hazards are potential hazards
that are not obvious, such as:
Injuries due to disregard of the
•
safety instructions, standards,
guidelines or regulations.
Danger due to work on the cables
•
and connections.
DANGER

ELECTRIC SHOCK!

• Never touch the mains plug on the
mains power cable with wet or damp
hands when plugging it in or
unplugging it.
• Do not carry out any work on the
appliance other than the cleaning and
service work described in this
instruction manual.
• Remove the mains plug from the plug
socket before starting cleaning or
service work.
• In an emergency, pull the mains plug
out of the plug socket immediately.
• Install and connect the appliance only
in accordance with the description in
the instruction manual.
• If the mains power cable or mains
plug is damaged, do not use the
appliance any more.
DANGER

HOT SURFACES

There is a risk of burns if you
touch the surfaces while the appliance is
switched on.
Page | 16

9 Putting into operation

Before opening, check the packaging for
damage.
IMPORTANT
Risk of damage!
Carefully open the packaging. Do not use
sharp knives or other pointed objects to
open the packaging.
Unpack the appliance as follows:
 Check if the delivery is complete.
 Check the appliance and the
individual parts for damage. If
this is the case, do not use the
appliance. Contact After Sales
Service. www.ggv-service.de

9.1 Using for the first time

Cleaning the appliance
1. Remove the packaging material
and all protective films.
2. Before using the appliance for the
first time, clean all parts of the
appliance as described in the
"Cleaning" section.
Setting up the appliance
Mount the appliance according to the
figure "Getting to know the appliance".
 Place the appliance in the middle
of a table out of reach of children.
 Place the appliance on a solid
table, do not use a soft base.