Electrical Requirements - Black and Decker BEAC75 Manual De Instrucciones

Enfriador por aire húmedo
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY INFORMATION
15. Do not tilt when placing or moving it after filling water, in order to
prevent water spilling.
16. If the product has been tilted or put in a horizontal position and has
water inside, immediately pull out the plug, and dry 24 hours before
starting again.
17. When the air cooler is operating, do not leave unattended for an
extended period of time.
18. Close supervision is necessary when any appliance is used by or near
children.
19. This appliance should not be used by persons (including children)
with reduced physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning its use by a person responsible for their
safety.
20. To reduce the risk of electric shock, do not remove screws. Do not
attempt to repair or replace parts.
21. Do not immerse the appliance or the power cord in water or other
liquids.
22. Do not operate your air cooler in a wet room such as a bathroom or
laundry room.
23. Do not use any detergents, glass or household cleaner, furniture
polish, gasoline, paint thinner or other solvent to clean any part of
the air cooler.
24. Do not block, cover or obstruct the air vents.
25. Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not
be tripped over.
26.
WARNING - To reduce the risk of fire or electric shock, DO NOT
use this air cooler with any solid-state speed control devices.
27. Do not use outdoors.
SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit into a polarized outlet only one way.
If the plug does not fit into the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug in any way.
Page 4
FOR FUTURE USE

Publicidad

Tabla de contenido
loading

Tabla de contenido