Reticulated Plate Installation; Reel Support And Packaging Plate Adjustment; Making The First Seal; Film Binding On Rewinder (If Present) - Minipack-Torre RP40 Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 6. Machine adjustment and setting up

6.4. Reticulated plate installation

The reticulated plate (12) can be placed according to the height of
the product to pack.
For a proper packaging the reticulated plate must be positioned
so that film sealing is at the half of the package height.
To position it follow this procedure:
Pull the reticulated plate in direction of the arrows

Remove it from the stops

Position the plate on the stops at the required height.


6.5. Reel support and packaging plate adjustment

The reel support (4) and the packaging plate (11) must be
adjusted according to the width of the article to be packaged,
leaving a space of about 1-2 cm between the article and the
welding edge.

6.6. Making the first seal

Place film as shown in the picture to carry out the 1st seal.
Lower the handle of the cover with your left hand and make a
pressure of 10-15 Kg.
Machine will automatically operate and the first seal will be
carried out on the side of the film.
With the right hand detach the film from the sealing blade.

6.7. Film binding on rewinder (if present)

Carry out a number of cycles sufficient to make a strip of scrap
film.
Guide this film strip around the transmission rollers (26) and (27)
and the control roller (28) and bind it to the rewinder (29).
The machine is now ready to start packaging.

6.8. Introducing the object to be packaged

With the left hand slide on the packaging plate the quantity of film
necessary to contain the product to be packed.
Introduce the product into the bag using the right hand and make
it slide to the left until it is laid on the screen leaving a little space
of about 1-2 cm to allow the passage of air for shrinkwrapping.
All manuals and user guides at all-guides.com
22
EN