Description (Fi G. A); Intended Use; Package Contents - Forch 5326 125 1 Manual Del Usuario

E N G L I S H
selected wheel. Proper wheel fl anges support
the wheel thus reducing the possibility of wheel
breakage. Flanges for cut-off wheels may be
different from grinding wheel fl anges.
e) Do not use worn down wheels from larger
power tools. Wheel intended for larger power
tool is not suitable for the higher speed of
a smaller tool and may burst.
Safety Warnings Specifi c for Wire Brushing
Operations
a) Be aware that wire bristles are thrown by
the brush even during ordinary operation.
Do not overstress the wires by applying
excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b) If the use of a guard is recommended
for wire brushing, do not allow any
interference of the wire wheel or brush
with the guard. Wire wheel or brush
may expand in diameter due to work and
centrifugal forces.
LABELS ON TOOL
The following pictographs are shown on the tool:
Read the instruction manual before use.
Wear safety glasses.
Wear ear protection.

Package contents

The package contains:
1 Angle grinder
2 Guard (115 mm/125 mm)
1 Side handle
1 Flange set
1 Two-pin spanner
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
54
All manuals and user guides at all-guides.com
Description (fi g. A)
WARNING: Never modify the power tool
or any part of it. Damage or personal injury
could result.

INTENDED USE

Your angle grinder 5326 125 1 has been designed for
professional grinding and cutting applications.
DO NOT use under wet conditions or in presence
of fl ammable liquids or gases.
DO NOT use grinding wheels other than center
depressed wheels and fl ap-disk.
These heavy-duty angle grinders are professional
power tools. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.
1 On/off switch
2 Spindle lock
3 Guard
4 Side handle
5326 125 1 - ANTI-VIBRATION SIDE HANDLE
The anti-vibration side handle offers added comfort
by absorbing the vibrations caused by the tool.
5326 125 1 - KEYLESS GUARD
The keyless guard allows for quick adjustment during
the application to enhance application versatility.
5326 125 1 - DUST EJECTION SYSTEM
The dust ejection system prevents dust pile-up
around the guard and motor inlet, and minimises the
amount of dust entering the motor housing.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your Förch tool is double insulated in
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 115 V units have to be operated
via a fail-safe isolating transformer with
an earth screen between the primary and
secondary winding.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and
you are competent to do this, proceed as
instructed below. If you are in doubt, contact
an authorized Förch repair agent or a qualifi ed
electrician.