Forch 5326 125 1 Manual Del Usuario página 56

E N G L I S H
• Press the spindle lock (2) and rotate the
spindle (11) until it locks in position.
• Tighten the fl ange (14) with the two-pin
spanner supplied.
• Release the spindle lock.
• To remove the disc, loosen the fl ange (14) with
the two-pin spanner.
WARNING: Do not use a damaged disc.
MOUNTING THE SIDE HANDLE (FIG. D)
• Screw the side handle (4) tightly into one of the
holes (14) on either side of the gear case.
Instructions for use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the
tool. Do not exert side pressure on the
disc.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
PRIOR TO OPERATION:
• Install the guard and appropriate disc or wheel.
Do not use excessively worn discs or wheels.
• Be sure the inner and outer fl ange are
mounted correctly.
• Make sure the disc or wheel rotates in the
direction of the arrows on the accessory and
the tool.
SWITCHING ON AND OFF (FIG. A)
• To run the tool, press the on/off switch (1).
• For continuous operation, press the switch
completely forward.
• To stop the tool, release the switch. To stop
the tool in continuous operation, press on the
back part of the switch.
WARNING: Do not switch the tool on or off
when under load.
METAL APPLICATIONS
• When using the tool in metal applications,
make sure that a residual current device (RCD)
has been inserted to avoid residual risks
caused by metal swarf.
• If the power supply is shut off by the RCD, take
the tool to authorised Förch repair agent.
56
All manuals and user guides at all-guides.com
WARNING: In extreme working conditions,
conductive dust can accumulate inside the
machine housing when working with metal.
This can result in the protective insulation
in the machine becoming degraded with
a potential risk of an electrical shock.
To avoid build-up of metal swarf inside the machine,
we recommend to clear the ventilation slots on
a daily basis. See "Maintenance".
USING FLAP DISCS
WARNING: Metal dust build-up
• Extensive use of fl ap discs in metal applications
can result in the increased potential for electric
shock. To reduce this risk, insert an RCD
before use and clean the ventilation slots
daily by blowing dry compressed air into the
ventilation slots in accordance with the below
maintenance instructions.
Optional accessories
WARNING: Since accessories, other than
those offered by Förch, have not been tested
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only Förch, recommended
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your Förch power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
POP-OFF BRUSHES
The motor will be automatically shut off indicating
that the carbon brushes are nearly worn out and that
the tool needs servicing. The carbon brushes are
not user-serviceable. Take the tool to an authorised
Förch repair agent.
LUBRICATION
Your power tool requires no additional lubrication.