Publicidad
Idiomas disponibles
Idiomas disponibles
Locating The Anti-Tip Bracket (See Figure 4)
Installations With Alternate Outlet Receptacle (Non-Flush Mount)
If the outlet receptacle must be mounted as shown in figure
4, the range will not push back against the wall.
Therefore, the long leg of anti-tip bracket will have to be on
the floor to properly engage the leveling foot.
E. Determine where either the right or left "EDGE" of the
range will be located and mark the floor or wall.
STEP 2 - Anti-Tip Bracket Installation Options
A. Installing Anti-Tip Bracket To Floor
1. Wood Construction: Locate the center of the two
holes identified in figures 3 and 4 as applicable, as
"HOLES FOR FLOOR." Drill a 1/8² (3 mm) pilot hole
in the center of each hole (a nail or awl may be used
if a drill is not available). Secure the anti-tip bracket
to the floor with the two screws provided.
Proceed to Step 3.
2. Cement or Concrete Construction: Suitable screws
for concrete construction can be obtained at the
hardware store. Drill the required size hole for the
screws obtained into the concrete at the center of
the holes identified in figures 3 and 4 as applicable,
as "HOLES FOR FLOOR". Secure the anti-tip
bracket to the floor. Proceed to STEP 3.
All manuals and user guides at all-guides.com
F. Place the bracket 15/16² (24 mm) from the marked
G. Use the bracket as a template and mark the required
FIGURE 4
-5-
"EDGE" toward the center of opening and against the
back wall as shown in figure 4, with orientation hole
against floor.
holes as shown in figure 4 for the type of construction
you will be using.
FIGURE 5
Publicidad
