Installation Requirements - Amana AMAP081BW Manual De Uso

INSTALLATION REQUIREMENTS

Electrical Requirements—All Models
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
The electrical ratings for your air conditioner are listed on the
model and serial number label. The model and serial number
label is located on the right-hand side of the air conditioner
cabinet.
Specific electrical requirements are listed in the "Electrical
Requirements" sections. Follow the requirements for the type
of plug shown in these sections.
Electrical Requirements—
115 V Models
Model BTUs − 6,000; 8,000; 10,000; 12,000; 15,000
All models −
115 volts − (103.5 min. - 126.5 max.)
■
If there is a "Single Circuit Only" label on the unit, use on a
■
dedicated single-outlet circuit only. If a dedicated single-outlet
circuit is not available,
then it is the customer's responsibility to have a single-outlet
circuit installed by a qualified electrician.
If there is no "Single Circuit Only" label on the
■
unit, the unit may be used on any branch circuit
of correct voltage and adequate current
protection rating.
6,000-8,000 BTU models −
0-8 amps
■
10-amp time-delay fuse or circuit breaker
■
10,000-15,000 BTU models −
0-12 amps
■
15-amp time-delay fuse or circuit breaker
■
Electrical Requirements—
230 V Models
Model BTUs − 18,000; 22,000; 24,000
230 volts (208 min. - 240 max.)
■
6.6-11 amps
■
15-amp time-delay fuse or circuit breaker
■
If there is a "Single Circuit Only" label on the unit, use on a
■
dedicated single-outlet circuit only.
If a dedicated single-outlet circuit is not available, then it is
■
the customer's responsibility to have a single-outlet circuit
installed by a qualified electrician.
If there is no "Single Circuit Only" label on the unit, the unit
■
may be used on any branch circuit of correct voltage and
adequate current protection rating.
Recommended Grounding Method
This air conditioner must be grounded. This air conditioner is
equipped with a power supply cord having a grounded 3 prong
plug. To minimize possible shock hazard, the cord must be
plugged into a mating, grounded 3 prong outlet, grounded in
accordance with all local codes and ordinances. If a mating
outlet is not available, it is the customer's responsibility to have
a properly grounded 3 prong outlet installed by a qualified
electrical installer. It is the customer's responsibility:
To contact a qualified electrical installer.
■
To assure that the electrical installation is adequate and in
■
conformance with National Electrical Code, ANSI/NFPA 70—
latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
3