BGS technic 70995 Manual De Instrucciones página 5

SPECIFICATIONS
1 Bolts M8x1.25
2 Upper plate
3 Fluid connector
4 Conical rubber
5 Lower plate
6 Nuts M8x1.25
DIMENSIONS
USE
1. Place the lower plate under the master cylinder reservoir's filler neck, see fig.1 next page.
2. Place the conical rubber on the master cylinder reservoir's opening, see fig.2 next page.
3. Insert the upper plate and the bolts on the reservoir, see fig.3 next page.
4. Fastens the nuts on the bolts until both nuts reach the lower plate.
5. Make sure the adapter is securely connected on the master cylinder reservoir, see fig.4 next
page.
6. Performing a low-pressure leak test is recommended before refilling brake fluid under pressure.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Hexagon 16 mm
Thickness: 5 mm (0.2")
90° angle
Material: EPDM
Thickness: 4 mm (0.16")
Outer diameter: 25 mm
Rubber Conical
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Lower Plate
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed