Declaration Of Conformity - Bosch GST Professional 120 E Manual Original

OBJ_BUCH-615-003.book Page 21 Friday, January 16, 2009 1:58 PM
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
16.12.2008
Bosch Power Tools
Assembly
Before any work on the machine itself, pull
the mains plug.
Replacing/Inserting the Saw Blade
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
If required, remove the dust cover 15 (see "Dust
Cover").
Insert the saw blade 13 (teeth in cutting direc-
tion) into the stroke rod until it latches 11.
While inserting the saw blade, pay attention that
the back of the saw blade is positioned in the
groove of the guide roller 12.
11
12
Note: If the grooves of the saw blade holder are
not in the position shown in the figure, then the
saw blade 13 cannot be inserted into the stroke
rod 11. Briefly press the SDS clamping lever 16
toward the side and release it again.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to inju-
ries.
2 609 932 673 | (16.1.09)
English | 21