Ferm CRM1054 Traducción Del Manual Original página 11

3. Move the mode selector I/0/II (20) into the
position 'I' to switch the appliance to start the
High pressure.
4. When the item to be inflated has reached the
preset valuepressure the unit will automatically
turn off.
NOTE: You may notice the actual pressure
reading may drop after a couple of seconds. This
is normal.
5. To stop the inflator at any time, move the
mode selector I/0/II (20) into the position 'O' to
switch the appliance off.
NOTE: If the power switch is turned off, all
settings will be lost and will need to be reentered.
This is a safety feature to prevent the risk of items
OVER INFLATING.
Note: After a few minutes the machine is
automatically turned off. In order to switch on the
machine, press the Pressure selector (21) and the
display (28) will go on.
Note: When using the Dunlop valve adapter,
the pressure gauge will not display an accurate
value due to characteristics of the valve. When
inflating a tire, do not use the value on the
pressure gauge, but inflate it by checking the
status of the tire. If the tool stops before the
tire reaches the desired air pressure, adjust the
pressure value, and then inflate the tire again.
Note: When inflating a floating tube, the
pressure gauge will not display an accurate
value since the pressure of floating tube is less
than 20 kPa (3 PSI). When inflating a floating
tube, do not use the value on the pressure
gauge, but inflate it by checking the status of
the floating tube.
Using the Inflator as a Pressure Gauge
Note: This machine has a memory mode in pre-
set function. Please make sure to switch machine
off to remove memory before using pressure
gauge function.
1. In order to switch on the machine, press the
Pressure selector (21) and the display (28) will
go on.
2. Reattach the hose connected to the valve to
be measured.
3. The digital readout will display the item's
pressure.
Removing the connection valve
Fig. D1, D2
• Removing with or without valve adapter: Open
the clamping lever (7) for the connection valve
(8) and remove from the valve and/or adapter
of the inflatable.
• Remove any adapter and close the valve of the
inflated item (ball, inflatables or tyres)
Note: Air may escape from the valve of the
inflatable when removing the connection valve (8).
Be sure not to remove the connection valve (8) too
quickly. It may be necessary to add extra pressure
to the required pressure, to compensate for the
escaped air.
Storage high pressure hose and valve adapters
Fig. F, G
• The high-pressure hose (9) is located in
a storage channel (10) on the back of the
machine. Wrap the high-pressure hose inside
the channel.
• The Valve adapters (14, 15, 16) are stored in
the back of the unit inside the valve adapter
storage (19).
LOW PRESSURE, high volume -
INFLATABLES - Switch 'II'
Inflating
Connecting the low pressure hose to the
compressor
Fig. H1
1. Remove the low pressure hose (11) from the
storage (12).
2. Line up the notches (24) of the hose with
the nubs (23) of the low pressure inflator
connection (22) .
3. Then, slide the hose on and twist counter-
clockwise to secure.
4. To remove, twist the hose clockwise and slide
hose off.
11