Connecting Lead Wire; Preparing For Session - TensCare Elise 2 Manual Del Usuario

strong sunlight, in a high temperature
location, in a pressurized container or in
a microwave oven.
Do NOT immerse in water or sea water,
or get wet.
Do NOT short-circuit.
Battery Caution
Caution: Do NOT use in a location
where there is a large amount of static
electricity, otherwise, the safety devices
in the battery
compromised.
Caution: If the battery pack creates an
odour, generates
discoloured or deformed, or in any way
appear abnormal
recharging or storage, immediately
remove it from the device or battery
charge and stop using it.
If necessary, to obtain a replacement
battery please send the device to
Tenscare. (See back cover for contact
details)
If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water and
immediately seek medical attention.
Warning: Keep batteries out of
the reach of children to prevent
them from swallowing them by
mistake. If swallowed by child, contact
doctor immediately.
Disposal: Always dispose of batteries
and device responsibly according to
local government guidelines. Do not
throw batteries onto a fire. Risk of
explosion.
pack may be
heat, becomes
during use,
20
12.2. CONNECTING LEAD
WIRE
Insert the lead wire plug into the base of
the unit.
Connect the lead from the base of
the unit to the lead in the probe.
Push the pin ends firmly into the pigtail
ends of the probe lead.
The lead wires may be damaged by
rough handling, and should be treated
with care.
12.3. PREPARING FOR
SESSION
1) Before using Elise 2, you will need to
visit the toilet.
2) Clean the probe with an alcohol-free
anti-bacterial wipe or with warm
soapy water.
3) Lubricate the
surfaces and probe tip with a water-
based lubricant, such as TensCare
Go Gel or water.
Caution: Do not use a silicone-
based lubricant
stimulation contacts as it may
decrease the effectiveness of the Elise
2's muscle stimulation.
metal electrode
on the