1. There is an additional igniter in the handle of the
heat gun. To change the igniter, press down on the
black switch to release the trigger. (See Figure 9)
2. Pull the trigger forward to expose black igniter.
(See Figure 10)
3. Remove black igniter from chamber and replace
with additional igniter located underneath the
handle of the gun. Make sure igniter tip is first
inserted into the chamber. Close trigger.
(See Figures 11-13)
PAGE 4 OF 15
MAINTENANCE
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
0122 IH-4693