FHF FernTel3 Instrucciones De Manejo página 39

Programming
In order to program the telephone, you have to allow modifications of the settings.
General
Use the Programming menu to modify the operating settings of the telephone. After lifting the
handset or pressing the disconnect key, a welcome message appears in the display.
Begin the programming procedure by pressing the
In the top line of the display, the text „Main menu" appears. In the second line, you see the
first menu item of the Main menu. The arrow > in front of the menu item indicates that this
item has been selected. Provided you have access to other menu items, pressing the
takes you to the next menu items, one at a time. Pressing the
top of the list of menu items.
The display shows a maximum of two menu items. When an arrow > is visible in front of an
item, it indicates that the item has been selected. The menu items denote further sub-menus.
Pressing the key activates a selected menu item.
Any sub-menu may contain further sub-menus as menu items. These sub-menus are
selected in the same manner as in the Main menu. Press the
or to leave the Main menu.
At the lower menu levels, so-called radio buttons are displayed for the selection of possible
settings.
Example:
Display
---Activate---
( ) None
( ) Direct call
>( ) No calls
=== End===
Pressing the C key activates a selected option.
In certain menus, values may be changed. These changes are made by pressing the
keys.
For all programming goes: Changes are applied and stored upon pressing the
By pressing the key, you leave the menu without applying the changes.
If a programming session has not been completed, the telephone leaves the Programming
menu after a certain amount of time (time-out).
If you want to modify the settings, you will be required to enter a four-digit PIN. The PIN set
by the factory is 0000.
Initial programming
In the as-delivered condition, the telephone already has a basic configuration enabling you to
make and answer calls. If you want certain settings regarding telephone book entries,
volume, dialling mode, or operation from private branch exchanges, you must use the
Programming menu.
Press the key to go to the Main menu.
The sub-menu „Programming" appears. Pressing the
where you may activate the sub-item „allow" by pressing the C key. You will be prompted to
enter the PIN (factory setting 0000). Programming is now allowed, and the complete Main
menu is at your disposal, including the following items:
- Telephone book
- Short / Speed code dialling
- Settings
Significance
Title line
Activated option
Option
Selected option
End of menu list
key.
key takes you back to the
key to go to a higher menu,
key takes you to the next level,
key
and
key only.
13