Troubleshooting; Troubleshooting The Charger - Stihl SL 100 Manual De Instrucciones

English

12 Troubleshooting

12.1 Troubleshooting the Charger

Fault LEDs on charger
Battery not being The LED (A) emits
charged. red light.
The LED "A"
flashes red.
LED "A" and LED
"B" do not light up
or flash.
The battery was The LED (A) emits
connected to the green light and the
charger and still LED (B) emits no
cannot be used. light.
The charger does not The LED (A) does
run a self test. not emit green light
for about 1 second
and then red for
about 1 second.
24
Cause
The battery is too warm or
too cold.
No electrical contact
between charger and
battery.
Malfunction in charger or
battery.
There is a fault in the
battery.
State of charge of the
battery is too low.
Electrical contact to
charger was briefly
interrupted.
Remedy
► Leave the battery connected to the charger.
Charging starts automatically as soon as the
permitted temperature range is reached.
► Disconnect battery and reconnect.
► Disconnect the battery.
► Disconnect the mains plug from the power supply.
► Disconnect the connecting cable from the charger.
► Wait for 1 minute.
► Connect the connecting cable to the charger.
► Insert the mains plug in a wall outlet.
► If the LED "A" continues to flash red: Do not use
the charger.
There is a malfunction in the charger.
► Connect the battery again.
► If the LED "A" flashes red again: Do not use the
battery.
There is a fault in the battery.
► Do not use the battery.
► Continue charging the battery until the LED (B)
emits green light.
► Disconnect the mains plug from the power supply.
► Disconnect the connecting cable from the charger.
► Wait for 1 minute.
► Connect the connecting cable to the charger.
► Insert the mains plug in a wall outlet.
12 Troubleshooting
0458-900-9921-A