Supplement; Technical Data - Vega VEGAWAVE S 61 Manual De Instrucciones

Ocultar thumbs Ver también para VEGAWAVE S 61:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8

Supplement

8.1

Technical data

General data
Material 316L corresponds to 1.4404 or 1.4435
Materials, wetted parts
Ʋ Tuning fork
Ʋ Process fitting
Ʋ Extension tube
Ʋ Process seal
Materials, non-wetted parts
Ʋ Housing
Ʋ Housing lid
Ʋ Seal ring (housing/housing cover)
Ʋ Ground terminal
Ʋ Cable gland
Ʋ Sealing, cable gland
Ʋ Blind plug, cable gland
Process fittings
Ʋ Pipe thread, cylindrical (DIN 3852-A)
Ʋ Pipe thread, conical (ASME B1.20.1)
Ʋ Pipe thread, cylindrical (EN 10226)
Sensor length (L)
Weight
Max. lateral load
Torque for NPT cable glands and Conduit tubes
Ʋ Plastic housing
Ʋ Aluminium/Stainless steel housing
Output variable
Relay output
Ʋ Switching voltage
Ʋ Switching current
Ʋ Breaking capacity
Ʋ Contact material
Ʋ Note
VEGAWAVE S 61 •
316L
316L
316L
Klingersil C-4400
Plastic PBT (Polyester)
Plastic PA 12 (polyamide, clear)
Silicone
316L
PA, stainless steel, brass
NBR
PA
G1½
1½ NPT
R1½
165, 500, 1000, 1500 mm (6.496, 19.69, 39.37, 59.06 in)
approx. 1500 g
600 N along the fork side
max. 10 Nm (7.376 lbf ft)
max. 50 Nm (36.88 lbf ft)
2 floating spdts (DPDT)
max. 253 V AC/DC
With circuits > 150 V AC/DC, the relay contacts must be
in the same circuit.
max. 3 A AC (cos phi > 0.9), 1 A DC
750 VA AC, 40 W DC (at U < 40 V DC)
If inductive loads or stronger currents are switched
through, the gold plating on the relay contact surface will
be permanently damaged. The contact is then no longer
suitable for switching low-level signal circuits.
AgNi or AgSnO2 each with 3 µm gold plating
8 Supplement
21

Publicidad

Tabla de contenido
loading

Tabla de contenido