Yakima Diamondback Base Track Manual Del Usuario página 2

2
3
POSITION THE TRACKS FOREWARD AND AFT.
Set the tracks on your vehicle in the
approximate location that you will install
them. Measure and position the track
ends equally from the front and rear of
the cover being sure to pay attention to
the locations of the crossmembers and
handles you identified in step 1.
4
POSITION THE REAR TRACK ENDS.
On each side of the rear tracks
(closest to the rear of the truck),
measure and position 2" from the edge
of the bend on the cover as shown.
6
MARK THE REAR PANEL HOLES.
Mark the rear-most hole for each
rear track. Use a marker to mark the
location of the holes at the ends of the
track closest to the rear of the vehicle.
Instruction #1036093B-2/9
Thouroughly clean your Diamondback Cover.
2X 2X
2X 2X
5
POSITION THE FRONT TRACK ENDS.
On each side of the front tracks
(closest to the center of the cover),
measure and position 2" from the edge
of the bend on the cover as shown.
7
MARK THE FRONT PANEL HOLES.
Mark the rear-most hole for each front
track. Use a marker to mark the location
of the holes at the ends of the track
closest to the rear of the vehicle.
2X 2X
2X 2X