Yakima Diamondback Base Track Manual Del Usuario página 5

INSTALL 1 BOLT, 1 WASHER, AND
14
1 CAPNUT ON EACH TRACK .
Install 1 bolt with 1 washer through each track
where you drilled the holes in step 13. Then
from inside of your cover, attach a cap nut.
Do not fully tighten the hardware yet.
16
DRILL THE REMAINING HOLES.
17
INSTALL THE END CAPS.
Press the end
caps on to the
ends of the tracks.
Instruction #1036093B-5/9
4X 4X
18
INSTALL THE WASHERS AND BOLTS.
Place the tracks
back into place
over the holes and
install 1 bolt with 1
washer through the
tracks and holes you
drilled. Then from
inside your cover,
attach the cap nuts.
Fully tighten the
hardware to 2 Nm.
8X 8X
15
MARK THE REMAINING HOLES.
Use a marker to mark 2 more holes on each
track. Try to space the holes as equal from one
another as possible. NOTE: Be sure the avoid the
potential obstructions you identified in step 1.
Remove the hardware
from each track and
remove all of the
tracks from the vehicle.
Drill an 1⁄8" pilot hole
through the center of
the marks you made
in step 15. Then drill
the holes to their final
diameter of 1⁄4". TIP: A
center punch can help
you to locate your pilot
hole more accurately.
8X 8X
NOTE: Carefully clear
away any debris to prevent
scratching your vehicle.
8X 8X
2 Nm
12X 12X