Yakima Diamondback Base Track Manual Del Usuario página 4

11
ENSURE THE TRACKS ARE SQUARE AND PARALLEL.
NOTE: This step is critical.
1. Using a measuring tape, measure the track
to track distances at your installed bolts (A).
2. Make sure distance B is equal to
measurement A.
3. Once A and B are equal, make sure the
outside corner to outside corner diagonal
measurements are equal as shown.
MARK THE HOLES AT THE
12
OTHER END OF THE TRACKS.
Without moving the tracks from the
parallel position you established in the
previous step, use a marker to mark the
holes at the opposite end of the tracks.
Instruction #1036093B-4/9
13
DRILL THE SECOND SET OF HOLES.
Pivot the tracks out of the way being careful
not to scratch your vehicle and drill an 1⁄8" pilot
hole through the center of the marks you made
in step 12. Then drill the holes to their final
diameter of 1⁄4". TIP: A center punch can help
you to locate your pilot hole more accurately.
Never
punch
or drill
through
the track!
4X 4X NOTE: Carefully clear away any debris
to prevent scratching your vehicle.