Publicidad
Idiomas disponibles
Idiomas disponibles
8
DRILL THE REAR PANEL HOLES.
Move the tracks aside and drill an 1⁄8" pilot hole
through the center of the marks you made
in step 6. Then drill the holes to their final
diameter of 1⁄4". TIP: A center punch can help
you to locate your pilot hole more accurately.
Never
punch
or drill
through
the track!
NOTE: Carefully clear away any debris
to prevent scratching your vehicle.
10
INSTALL 4 BOLTS, 4 WASHERS, AND 4 CAPNUTS.
Install 1 bolt with 1 washer through each track where you drilled the holes in steps 8 and 9.
Then from inside your cover, attach a cap nut. Do not fully tighten the hardware yet.
Instruction #1036093B-3/9
9
DRILL THE FRONT PANEL HOLES.
Move the tracks aside and drill an 1⁄8" pilot hole
through the center of the marks you made
in step 7. Then drill the holes to their final
diameter of 1⁄4". TIP: A center punch can help
you to locate your pilot hole more accurately.
Never
punch
or drill
through
the track!
2X
2X
NOTE: Carefully clear away any debris
to prevent scratching your vehicle.
2X
2X
4X
4X
Publicidad
