Adjust System Settings; Additional Information; Reset The System; Replace The Fuse - Philips CE235BT Manual De Usuario

11 Adjust system
settings
1
Press to access system settings.
2
Press or repeatedly until one of the
following settings scrolls.
• [BEEP], [DIMM], or [DANCE]
3
Rotate to change the setting.
[BEEP] [BEEP ON]
[BEEP OFF]
[DIMM] [DIMMER HIGH]
[DIMMER LOW]
[DANCE] [DANCE ON]
[DANCE OFF]
EN
20
12 Additional

Reset the system

If the system works abnormally, reset the
system to factory default settings.
Enable the
beep sound
of buttons.
Disable the
beep sound
of buttons.
Increase the
brightness
level of the
screen.
1
Decrease
Detach the front panel.
the 2
Press the RESET button with the tip of a
brightness
ball-point pen or toothpick.
level of the
» All settings are reset to factory default.
screen.
Enable the
spectrum

Replace the fuse

on the LCD
display.
If there is no power, check the fuse and replace
Disable the
it if it is damaged.
spectrum
1
on the LCD
Check the electric connection.
2
display.
Remove the damaged fuse from the rear
panel.
3
Insert a new fuse with the same
specifications (15 A).
information