Tivoli Audio MUSIC SYSTEM BT Instrucciones página 12

4. You will hear a ring tone from the Music System BT confirming connection and you can begin
playing your music files wirelessly. Adjust the volume level on your device. You should not have to
pair your device again. Depending on your device, you may need to make multiple attempts
at Pairing and/or Connecting to the Music System BT, but please give your device adequate
time to Pair or Connect before repeating the process.
Pairing A Bluetooth Wireless Technology Enabled
iPhone/iPod touch/iPad
1. Switch the Music System BT's source to Bluetooth/AUX using the source button. This will power
on the Bluetooth. Turn the volume up about ¼ to start. Also turn up the volume on the source
device (the device you are streaming from).
2. Select "Settings" (depending on your device's software version).
3. Select "General".
4. Select "Bluetooth".
5. Switch Bluetooth "On" to initiate searching.
6. Select "Tivoli Bluetooth (Not Paired)" when it appears on the display. If you are prompted to enter
a PIN, enter "0000". "Tivoli Bluetooth will change from "Not Paired" to "Connected".
7. You will hear a ring tone from the Music System BT and you can begin playing your music files wire-
lessly. Adjust the volume level on your device. You should not have to pair your iPhone/iPod/iPad again.
The volume output level of music files varies. If you prefer an even higher output level, check the settings
in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of "Tivoli Bluetooth" on your
iPhone/iPod touch/iPad display and select "Forget this Device", then repeat the Pairing process.
Depending on your device, you may need to make multiple attempts at Pairing and/or
Connecting to the Music System BT, but please give your device adequate time to Pair or
Connect before repeating the process.
When streaming music, you can press the blue arrow to the right of the next track button >>| on the
iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and Bluetooth.
NOTE:
• The Music System BT will remember pairing information for up to 8 devices. Additional devices
can be paired, but the least-recently used device will be replaced by the newly paired device.
• If the audio drops out or stops during playback, move your device closer to the Music System
BT, or check to be sure another wireless device is not interfering with the signal.
• When switching from Bluetooth to AM, FM, or CD, you may need to re-adjust (lower) the radio's
volume level.
Important Notes About the CD Player
• The display does not show the total disc time for MP3/WMA CDs due to their often very lengthy
table of contents. Total time will be shown for commercial music CDs but if either track +/- but-
tons are pressed, the total time will disappear since the initial mode was changed
• Playback will be delayed slightly while the table of contents is read.
• Disc functions will not work while the disc is loading.
12 – ENGLISH