Dry Ironing - Orbegozo VP 8550 Manual De Instrucciones

VP 8550
UTILIZATION
This product has two options: You can dry or steam iron:

Dry ironing

1. Place the iron on the insulating base
2. Connect the cable and the temperature indicator will begin to illuminate.
3. Turn the temperature dial to your desired position, which will depend on the type of fabric.
You will find the section "Ironing tips" below to help you with this. The temperature of the
soleplate begins to rise and the temperature indicator will remain on.
4. When the temperature indicator turns off, it means that it has reached the selected
temperature and you can start ironing.
ATTENTION: Never touch the soleplate until it has cooled down!
Steam ironing
1. Place the iron on the insulating base.
2. Grasp the handle of the tank and pull horizontally. Fill the tank with water through the
opening and put the tank back in place (FIG 4). Preferably use softened water. The maximum
capacity of the tank is 1.2L. The water level should not exceed the maximum.
Grasp the water
tank handle
3. Plug in the device and select the required temperature on the dial.
4. When the temperature indicator lights up the iron will begin to heat up.
5. After a few minutes the temperature indicator will turn off, indicating that the soleplate has
reached the desired temperature. You can now steam iron.
6. Press the steam nozzle lightly. Steam will come out of the soleplate continuously.
NOTE: There may be a drip when the temperature is lower than 2nd power. It is normal.
Rem ove the water tank
horizontally
Fill the water tank
with water
Replace the water tank
18