Maintenance / Service; Declaration Of Conformity - Skil 1735 Manual Original

slight pressure on the tool needed to keep the
0
! clean and lightly lubricate the SDS+ accessory
before insertion
SDS+ chuck while turning and pushing it until it
! the SDS+ accessory requires freedom of
movement which causes eccentricity when tool is
off-load; however, the accessory automatically
centres itself during operation without affecting
drilling precision
! do not use bits with a damaged shank
interrupted (causing a rattling noise)
- switch on tool again
! while working, always hold the tool at the
grey-coloured grip area(s)
- always use auxiliary handle G 2 (can be adjusted
as illustrated)
APPLICATION ADVICE
! only use sharp bits
SDS+ chuck while turning and pushing it until it
- set switch E 2 to normal drilling (only activate when
tool is switched off and plug is disconnected)
the wood
2
!
@
#
$
2 and insert adapter in
%
^
&
*

MAINTENANCE / SERVICE

! disconnect the plug before cleaning
power tools
- send the tool undismantled
the tool are listed on www.skil.com)
ENVIRONMENT
Do not dispose of electric tools, accessories and
packaging together with household waste material
(
disposing occurs

DECLARATION OF CONFORMITY

Technical file at
1Öêàáå"îÖå"ÚÛê",ççÜÚÛå
3èÛêÖìàçåë"ﾏ")åÝàåÛÛêàåÝ
7/-0")íêçèÛ"&: "♂"∞♀"&("&êÛÚÖ "20
14.01.2013
NOISE/VIBRATION
✱
✱
increase
8
3ãÖÜ"(àáâÝêÖÖÜ
%èèêçîÖã"1ÖåÖÝÛê