Changing The Engine Oil; Sharpening / Changing The Blades; Adjusting The Carburettor; Storage - FLORABEST FBM 190 A1 Traducción Del Manual De Instrucciones Original

GB MT
turning.
2. Unscrew the spark plug anti-
clockwise using the enclosed
spark plug socket.
3. Check the spark gap using a
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.76 mm.
4. If necessary, adjust the gap by
carefully bending the ground
electrode on the spark plug.
5. Clean the spark plug with a wire
brush.
6. Insert the cleaned and adjusted
spark plug or replace a dam-
aged spark plug with a new one
(recommended torque 20 Nm)
(see "replacement parts").

Changing the Engine Oil

To change the engine oil, tip the
equipment backwards on the han-
dle bar (see
ating fluids from leaking out, do not
lie the equipment on its side.
• Change the engine oil for the
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
• Change the engine oil when the
engine is warm.
• Dispose of the used oil in an
ecofriendly manner (see "dis-
posal / environmental protec-
tion").
1. Open the oil drain plug (34)
(female square drive) on the bot-
tom of the equipment.
2. Drain the engine oil into a suit-
able container.
70
). To prevent oper-
3. Wipe up spilt engine oil and
screw back in the oil drain plug
(34).
4. Stand the equipment level and
refill the engine oil (see "initial
operation").
Sharpening / Changing the
Blades
• Always have a blunt blade resharp-
ened by a specialist workshop, as an
imbalance check can be carried out
there.
• Always have a specialist workshop
change a damaged or imbalanced
blade. Incorrect installation can result
in serious injury.

Adjusting the Carburettor

The carburettor has been preset in the
factory for optimum performance. If read-
justments are required, have the adjust-
ments made by a specialist workshop.

Storage

General Storage Instructions

Do not store the equipment
with a full collection box. In hot
weather, the grass begins to fer-
ment when heat is generated.
Risk of fire.
• Clean and service the equipment be-
fore storage.
• Allow the engine to cool before stor-
ing the equipment in enclosed areas.
• Use suitable and authorised contain-
ers for storing fuel.
• Keep the equipment in a dry place