Tabla de contenido
Publicidad
ENGLISH
Auto mode
The device will automatically set the most suitable speed according to the air quality:
When air quality is bad, the device will automatically activate high speed, while the air quality
light indicator turns on red;
When air quality is good, the device will automatically activate low speed, while the air
quality light indicator turns on yellow;
When air quality is optimum, the device will automatically activate Sleep mode, while the air
quality light indicator turns on blue.
Sleep mode
Press the Speed button to enter the Sleep mode. All light indicators will turn off except for the
Sleep icon. Press any button to quit Sleep mode.
Filter reset
Once the air purifier is turned on, the Filter reset will start counting down. If the air purifier is
turned off and restarted, it will continue to count down.
The filter is designed to be reset after 2000 hours of use. Once it has been used for this time,
the Filter reset indicator will blink.
Once the filter has been replaced, press Filter reset for 3 seconds, the light indicator will turn
on.
Ioniser
Press the Ioniser button to switch the ionising function on and off. The corresponding light
indicator will light up.
Wi-Fi
In order to link your product with our App, please follow the below steps.
Download the EnergySilence App from Google Play or App Store.
If it is the first time you use it, register an account. If not, log in.
Once you have entered the App, press "+" on the top right-hand corner and tap "TotalPure 1500".
Turn your device on, press the Wi-Fi button until the device beeps. Check that the button light
indicator is blinking quickly and if it is not, press the button again.
Enter your Wi-Fi password and press confirm.
The robot linking process will start automatically.
If the automatic linking process fails, press the Wi-Fi button again until the device beeps.
Check that the button light indicator is blinking slowly.
Confirm the Wi-Fi password again and follow the instructions indicated by the App.
22
TOTALPURE 1500 CONNECTED
4. CLEANING AND MAINTENANCE
Turn off and unplug the product from the power supply before cleaning or repairing it.
Use a soft, dry (or slightly damp) cloth with some neutral cleaning agent to clean the
product's outside and prevent the accumulation of dust and dirt.
If the product is not going to be used for a long time, store it in a safe and well-ventilated place.
Do not use detergent, scouring pads, chemically-treated cloths, gasoline, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water leakage.
Do not immerse the product in water or other liquid.
Maintenance and repair
Rotate the base all the way anticlockwise and then remove it.
Take the high-efficiency filter out and clean it or replace it.
Fig. 4.
Assemble the product back by replacing the base and turning it clockwise.
Fig. 5.
Hold down the light button for 5-7 seconds in order to reset the filter reposition countdown.
The light will stop blinking and turn off.
Do not wash the filter.
Note: If the device no longer eliminated odours, the filter must be cleaned or replaced with a
new one.
5. TECHNICAL SPECIFICATIONS
Product reference: 05625
Product: TotalPure 1500 Connected
26 W, 220-240 V~, 50 Hz
Wi-Fi frequency band (GHz): 2.2 GHz
6. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimize the recovery
and recycling of the materials they contain, and reduce the impact on
human health and the environment.
ENGLISH
TOTALPURE 1500 CONNECTED
23
Publicidad
Tabla de contenido
