Tabla de contenido
Publicidad
Stationary Air Compressor
Maintenance
Do not attempt to
tamper with this
valve. This valve should be checked
occasionally. If air leaks after the ring
has been released, or the valve is stuck
and cannot be actuated by the ring, the
safety valve must be replaced.
2. With motor OFF and unplugged,
clean debris from motor, flywheel,
tank, air lines and pump cooling fins.
DRIVE BELT
Belts will stretch in normal use. Properly
adjusted, a 5-pound force applied to
the belt between the motor pulley and
the pump will deflect the belt about
1/2"(See Figure 9).
1/2" Deflection
Figure 9
TO ADJUST DRIVE BELT:
1. Remove belt guard.
2. Loosen the four fasteners holding
the motor to the baseplate.
3. Shift the motor in the proper
direction. The belt must be properly
aligned when adjustment is made.
Notes
(Con't)
Operation
Check Oil Level
Drain Tank
Check Air Filter
Check Safety Valve
Blow Dirt From Inside Motor
Check Belt Tightness
Change Oil
Touch Rim At
Two Places
Figure 10
4. To align belt, lay a straightedge
against the face of the flywheel
touching the rim at two places (See
Figure 10).
5. Adjust flywheel or motor pulley so
that the belt runs parallel to the
straightedge (See Figure 10).
6. If necessary, use a gear puller to
move the pulley on the motor shaft.
Tighten setscrew after pulley is
positioned.
7. Attach belt guard.
MAINTENANCE SCHEDULE
Daily
STORAGE
Straight Edge
Parallel With Belt
TECHNICAL INFORMATION
For information on the operation or
repair, please call 1-800-543-6400. In
Ohio or outside the continental U.S.,
call 513-367-4811.
6
Weekly
Monthly
1. When not in use, hose and
compressor should be stored in a
cool dry place.
2. Tanks should be drained of moisture.
and hose should be disconnected and
hung with open ends down to allow
any moisture to drain.
3. Protect the electrical cord from
possible damage by winding the
cord loosely around the handle of
the unit or coiling the cord up.
3 Months
Publicidad
Tabla de contenido
