Using The Infant Carrier With The Base; Attaching Infant Carrier To Base; Releasing Infant Carrier From Base - Cybex Platinum CLOUD Q Manual Del Propietário

ATTACHING INFANT CARRIER TO BASE

1. Make sure handle is LOCKED in the CARRY position.
2. Lift Infant Carrier by the Handle and slide the Attachment
Rod under the Attachment Catch on the Base.
3. Rotate foot end of the Infant Carrier down onto
the Base until an audible CLICK is heard.
4. Move handle to the DRIVE postion.
The green Safety Button will pop out from the middle of the Infant
Carrier Release to indicate proper attachment.
The Cloud Q is allowed to touch the vehicle seat(s) in front of it, as
long as the recline angle of the Cloud Q is not affected.
ALWAYS have the handle locked in the DRIVE position
while using this child restraint in a vehicle.

RELEASING INFANT CARRIER FROM BASE

If used, retract the L.S.P. device. See page 42.
1. Press the green Safety Button
the Infant Carrier Release down
2. Slightly tilt Infant Carrier toward front of vehicle.
Grasp Infant Carrier with both hands to lift off.
ALWAYS verify that the handle is LOCKED in the Carry
position before lifting Infant Carrier by the handle. An
unlocked handle could move unexpectedly, causing
child to fall out.

USING THE INFANT CARRIER WITH THE BASE

a
in while pushing
b .
1
4
1
a
b
3
2
Correct in vehicle
DRIVE handle position.
2
36