Jocel JF206I Manual De Instrucciones página 44

W D
540 551
Note：Figure 1, Figure 2 only as a product space demand size schematic diagram.
3. Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give
rise to vibration and noise. When the refrigerator is placed on such flooring materials as carpet,
straw mat, polyvinyl chloride, the solid backing plates should be applied underneath the
refrigerator, so as to prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded
structure.
Preparations for use
1. Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately.
Make sure to energize the refrigerator after more than 1 hour of standing, so as to ensure its
normal operation.
2. Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
3. Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door,
if the temperature inside the freezer compartment drops obviously, it indicates the
refrigeration system is working normally.
4. Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will
be automatically controlled according to the user's temperature setting. After the refrigerator is
fully cooled, put in foods, which usually need 2~3 hours to be fully cooled. In summer, when
the temperature is high, it takes more than 4 hours for the foods to be fully cooled (Try to open
the refrigerator door as less as possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the
ground wire and leakage circuit breaker are normal. If vibration noises are produced
due to the refrigerator contacting the wall or if the wall gets blackened by air convection
H A
1428 910 1054
B C(°)
130±5
44
E F Model
50 100 JF211I