Installing Vacuum Hose/Wand; Machine Setup - Tennant 3220 Manual Del Operador

4. Secure power cord with factory-installed cord
clamp, located on handle (Figure 2).
5. Wrap power cord around quick release hook and
the lower handle hook.

Installing Vacuum Hose/Wand

1. Slide hose cuff over spout on bag compartment lid
and wand into base cuff as shown. Snap wand
into retainer clip (Figure 3).
2. Store crevice tool on carrying handle (Figure 3).
Spout

MACHINE SETUP

WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
1. Install filter bag (pre--installed). Depress latch on lid
to open bag compartment (Figure 4).
Contact distributor for optional cloth bag #900034.
NOTE: The machine will not operate without a filter
bag in place. The protective vacuum motor lockout
device will automatically sense when a bag is not
installed.
Tennant 3220 (11- -99)
All manuals and user guides at all-guides.com
FIG. 2
Wand
Base
Cuff
FIG. 3
2. Adjust brush height. Turn brush height adjustment
dial to desired setting as follows (Figure 5):
Brush Height Settings:
1--2 Short Carpet Pile
3--4 Medium Carpet Pile
5--6 High Carpet Pile
OPERATION
FIG. 4
FIG. 5
5