Fitting The Accessory Tool; Removing The Accessory Tool - Hilti SBT 4-A22 Manual De Instrucciones Original

▶ Fit or adjust the side handle.

5.5 Fitting the accessory tool

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.

5.6 Removing the accessory tool

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
5.7 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself
and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
▶ Fit the belt hook.
6 Operation
CAUTION
Risk of injury if the accessory tool stalls !
▶ Check that the side handle is fitted correctly and tightened securely.
Always hold the tool with both hands on the grips provided.
▶ Wear eye protection to prevent splintering material from injuring your
eyes.
Observe the safety instructions and warnings in this documentation and on
the product.
*2184702*
3
2184702 English 9