Accessories (Optional) - Nice Oview Instrucciones Y Advertencias Para La Instalación Y El Uso

1
PRODUCT DESCRIPTION
AND USE
Oview is a device designed for the programming and control of Nice devices
equipped with "BusT4", used for the automation of gates, garage doors, road
barriers with mobile arms and similar applications.
Any other use is to be considered improper! The manufacturer declines all
liability for damage resulting from improper use of the product and other
than as specified in this manual.
1.1 – Main operating characteristics of Oview
The Oview device dialogues with other devices via the BusT4 cable; therefore it
can only communicate with products fitted with the BusT4 connector, i.e. those
in the "NiceOpera" system (for information on this system, refer to the box
alongside, entitled "What is Nice Opera?").
Oview is only activated when connected to a device, as it is powered directly by
the latter.
Oview can be used both as a system for programming devices and as a system
for automation control. Use of Oview is especially recommended in automation
systems with an advanced technological content, as it enables:
– programming of a device or several devices connected on a network;
– control of one or more automations;
– diagnostics of a device or several devices connected on a network.
– storage(*) of settings and programming of devices (storage is useful for
example to enable rapid re-configuration of devices in the event of a replace-
ment of a system component).
(*)Note – The storage operation is only available when using the optional soft-
ware available for use with Oview (see chapter 7).
Oview is suitable for use both by the installer and user. Just one Oview device
enables the installer to program and modify data, and perform maintenance on
all devices present in a system. On the other hand, the user can use Oview to
control one or more automations on a daily basis.
If required, the installer can also provide the user with the programming settings
of a number of parameters. This can be useful if the user needs to change the
values of these parameters while using the automation.
If the case of a network of several devices, use of Oview enables the installer to
3 – English
All manuals and user guides at all-guides.com
configure all devices in a system one at a time, thus reducing the complexity,
times and movements normally required for such operations.
Note – For more information on how to construct a Bus network and how to
configure and manage the network by means of Oview, refer to the manual
"NiceOpera System Book" available on the website www.niceforyou.com
1.2 – Accessories (optional)
Oview is supplied with a 2 m cable for direct connection to a device and a sup-
port for wall-mounting.
All the other accessories listed below are optional:
– Bluetooth
– Gsm
module, supplied with the Software "Oview Software Suite";
®
module, supplied with the Software "Oview Software Suite".
®
What is "NiceOpera"
Nice Opera is a system comprising various devices normally used in systems
for the automation of gates, garage doors, and road barriers with mobile arms.
These devices are:
– transmitters in the series NiceOne;
– receivers in the series NiceOne;
– control units of gearmotors with "Bus T4" connection.
There are also other supplementary software and hardware devices in addition
to the above:
– O-Box programming unit with dedicated software, for transmitters and
receivers;
– Oview programming unit, for control units and receivers;
– a Bluetooth module and dedicated software, for data communication
®
between Oview and a Personal computer or Palmtop;
– a GSM module and dedicated software, for data communication via
®
Internet between Oview and a Personal computer or Palmtop.
The Gsm module also enables the use of a smartphone and stan-
®
dard mobile phone: these can be used to send a command to an
automation by means of a call or text message; also, the smart-
phone, equipped with the Windows
enables use of the software "Oview software suite".
Mobile operating system
®