Assembling The Vacuum Cleaner; Using The Vacuum Cleaner - Sinbo SVC 3459 Guía De Uso

USING

ASSEMBLING THE VACUUM CLEANER

Always remove the plug from the power socket before fitting or removing accessories!
1. Fitting the flexible hose
Insert the flexible hose into the air intake duct at the front of the appliance. Press until
it clicks into position.
2. Removing the flexible hose
Remove the plug from the power socket. To release the flexible hose, firmly squeeze the
release buttons on both side and pull out from the air intake duct.
3. Fitting the extension tube and floor brush
Simply insert the tube into the available end of the flexible hose and insert the floor brush
to the other end of the tube. Adjust the telescopic tube to the desired length.

USING THE VACUUM CLEANER

1. Assemble the vacuum cleaner as described above.
2. Before using the appliance, unwind a sufficient length of cable and insert the plug into
a suitable 230V ~ 50Hz power socket. A yellow mark on the power cable shows the ideal
cable length.
CAUTION: Do not extend the cable beyond the red mark and never pull out or retract the
cord while the machine is running.
3. Press the ON/OFF button to switch the appliance on.
4. Choose a suitable adjustable floor brush position for surface to be cleaned:
a) Carpets – The bristles should be in (retracted) to enable the floor head to glide on the
carpet.
b) Hard Floors – The Bristles should be out (extended).
5. To adjust the suction power, rotate the speed control knob clockwise to increase the
suction and anti-clockwise to decrease the suction.
6. Keep an eye on the dust barrel and when it is half full, it is time to empty it
7. To rewind the power cord, turn off the vacuum cleaner and unplug from the power
socket. Press down on the cord rewind button with one hand and guide the power cord
with the other hand to ensure that it does not whip causing damage or injury.
EMPTYING THE VACUUM CLEANER
Emptying the dust barrel
Always unplug the unit from electrical outlet before removing the dust barrel.
1. Press the knob on the top of the dust barrel.
2. Lift dust barrel back and up.
3. Hold the barrel over a rubbish bin or other suitable area for collecting the contents
of the barrel.
4. Press the knob at the bottom end of dust barrel to open the dust barrel cover. The
contents are emptied from the bottom of the barrel.
5. Refit the dust barrel to the vacuum cleaner
- 10 -