Turn On The Camera - Num'axes PIE1048 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6. Operation

6.1. Turn ON the camera

Any time after the batteries and SD card have been inserted, you can switch on the camera.
Put the switch in the "ON" position; the camera is ready to work.
The LCD display will count down 15 seconds. This interval allows you time to close the
camera front cover and leave the monitored area.
Once in the ON mode, the camera will take photos or videos according to its current
parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. In order to test or
use the device, you only need to insert the SD card and AA batteries then power on the
camera (switch in the ON position).
6.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very low level.
Therefore, please remove the batteries if the camera will not be used for a long time.
The OFF mode is the "safe mode" for actions such as: replacing the SD card or batteries, or
transporting the camera.
You will also use the OFF mode when you will connect the camera to a computer's USB port
to download your photos/videos.
6.3. Customizing the settings / TEST mode
In order to check or change the settings, slide the switch to the TEST position (the LCD
screen will light up) then press the MENU button (the setting menu appears on the LCD
screen).
You can navigate the setting interface by pressing the UP  and DOWN  buttons. Press
the OK button to enter parameters or to save a setting. Press the MENU button to return to
the previous page.
Settings
Mode
PIE1048 - Indice A – Juillet 2020
Programmable options (default settings in bold characters)
Photo / Video / Photo + Video
 Photo: the camera shoots only photos.
 Video: the camera shoots only videos.
 Photo + Video: upon the same trigger event, the camera shoots
a photo first then a video.
24/88

Publicidad

Tabla de contenido
loading

Tabla de contenido