Operating The Machine; Working Instructions; Adjusting The Mitre Angle - Worx WX760.1 Manual Del Usuario

Actuate the spindle lock only when the
cutting disc is at a standstill.
Removing the Cutting Disc
place the machine in the working position.
Swing the pendulum protection hood (3)
upwards to the stop.
Turn the hex head bolt (19) anticlockwise
with the spanner (14) provided while
pressing the spindle lock at the same time
until it engages.
Keeping the spindle lock depressed then
unscrew the hex head bolt. Remove the
washer (18) and the clamping flange (17).
Remove the cutting disc.
Installing the Cutting Disc
If necessary, clean all parts to be mounted.
place the new cutting disc on the tool spindle
(16) so that the label points away from the
tool arm.
place on the clamping flange, the washer and
screw in the hex head bolt.
press the spindle lock until it engages and
tighten the hex head bolt clockwise.
Guide the pendulum protection hood back down.

3. ADJUSTING THE mITRE ANGLE

The mitre angle can be set in a range from 0°
to 45°.
Often used angles are identified on the angle
stop (12) with appropriate marking. The 0°
and 45° positions are set at the end stops.
Loosen the two fence bolts (11 & 13) with the
spanner provided. Set the desired angle and
retighten the fence bolts.
4. CLAmPING THE WORK PIECE (See
Fig. C)
To ensure optimum work safety, the work
piece must always be firmly clamped.
place the work piece against the fence of the
angle stop. Slide the clamping spindle against
the work piece and clamp the work piece
firmly with the aid of the spindle handle.
Releasing the Work Piece
Loosen the spindle handle. Release the
locking lever and pull the clamping spindle
away from the work piece.
Cut off saw
All manuals and user guides at all-guides.com

5. OPERATING THE mACHINE

Switching On and Off (See Fig. D)
To switch on, slide the button (21) to the left.
Then press the on/off switch (20) and hold it
depressed .
For safety reasons, the on/off switch
of the machine cannot be locked on
but must remain depressed during
operation.
To switch off the machine, release the on/off
switch.

WORKING INSTRUCTIONS

maximum work piece dimensions [mm]
Work piece form
Do not load the machine so heavily that the
disc comes to a stand still.
Advancing too fast considerably reduces the
performance capabilities of the machine and
shortens the service life of the cutting disc.
The cutting disc becomes very hot while
working; do not take hold of it until it has
cooled.
Use only cutting discs that are suitable for
the material to be worked.
DEPTH STOP
As delivered, the depth stop is set so that a
new 355mm cutting disc does not touch the
mitre angle
0° 45°
120 outer 110 outer
Dia. Dia.
110 x 110 96 x 96
80 x 210 70 x 120
135 x 135 88 x 88
EN
11