Other Features - Haier QDHR20 Manual Del Propietario Y Instrucciones De Instalación

CONTROLS
Appearance may vary by model.
Cont rols
NOTE: When t he bucket is full or removed, t he cont rols cannot be set .
1. Power Pad
Press t o t urn t he dehumidifier on and off.
NOTE: Turning off t he power by pressing t he Power but t on does
NOT disconnect t he appliance from power supply.
Cont rols t he fan speed.
Press t o select eit her High, Medium, Low, or Smart Dry fan speed.
Set t he fan cont rol t o High for maximum moist ure removal. When
t he humidit y has been reduced and quiet operat ion is preferred,
set t he fan cont rol t o Medium or Low.
Smart Dry compares t he set humidit y level wit h t he act ual
humidit y and adjust s t he fan speed aut omat ically.
3. Display
Shows t he set % humidit y level while set t ing, t hen shows t he
act ual (+/ – 5% accuracy) room % humidit y level.
in Nonst op mode for cont inuous operat ion. To set t he unit for
cont inuous operat ion, press t he
indicat or light is illuminat ed.
NOTE: If Nonst op is select ed, t he dehumidifier will operat e
cont inuously at it s maximum dehumidificat ion set t ings if
at t ached t o a hose t o drain or unt il t he bucket is full.
For drier air, press the pad and set to a lower percent value (%).
For damper air, press the pad and set to a higher percent value (%).
When you first use t he dehumidifier, set t he humidit y cont rol
t o 45% or 50%. Allow at least 24 hours for t he dehumidifier
t o achieve t he humidit y level. If you st ill have damper air t han
Ot her Feat ures
Alarm
If t he bucket is full or missing, an alarm will sound for about 10 seconds t o
remind you t o empt y and replace t he bucket .
Aut o Shut Off
The Wat er Level Cont rol Swit ch shut s off t he dehumidifier when t he bucket
is full, or when t he bucket is removed and/ or not replaced in t he proper
posit ion.
NOTE: The fan and compressor will st op running as soon as t he bucket is
49- 5000430 Rev. 4
pad unt il t he "Nonst op"
desired, set t he humidit y level t o a lower set t ing or select
Nonst op for maximum dehumidificat ion.
5. Filt er Timer
Aft er 250 hours of operat ion, t he Clean t he Filt er indicat or light will
glow t o remind you t o clean t he filt er. Remove t he filt er and clean it .
Press and hold Filt er but t on for 3 seconds t o reset t he filt er
reminder. See t he Care and Cleaning sect ion.
6. Delay Off
While t he dehumidifier is operat ing press t he Delay but t on.
Press t he / but t ons t o select t he number of hours you want
t he dehumidifier t o cont inue t o operat e before t urning Off.
NOTE: Aft er displaying t he t ime, t he Display will revert t o
showing t he current humidit y aft er 5 seconds have passed.
Pressing t he Delay but t on will display t he number of hours left on
t he delay.
Delay On
While t he dehumidifier is off press t he Delay but t on.
Press t he / but t ons t o select t he number of hours you
want t he dehumidifier t o remain off before t urning On.
NOTE: The display will show t he number of hours left unt il t he
dehumidifier t urns on.
To cancel t he Delay:
Press t he Dela y but t on once, t he hours remaining on t he Delay
will appear on t he display. Press t he Delay but t on again and t he
Delay will be cancelled.
7. Empt y Indicat or
The "Empt y" indicat or will blink when t he bucket is ready t o be
empt ied, or when t he bucket is removed and/ or not replaced in
t he proper posit ion.
removed. The alarm will sound if t he bucket is not replaced in t he proper
posit ion aft er 3 minut es.
Aut o Defrost
When frost builds up on t he evaporat or coils, t he compressor will cycle off
and t he fan will cont inue t o run unt il t he frost disappears.
Power Out age
In t he case of a power out age or int errupt ion, t he unit will aut omat ically
rest art , in t he set t ings last used, aft er t he power is rest ored.
5