Attaching Handle - Uline TORNADO H-9934 Manual Del Usuario

POWER CORD, TWO-WIRE POLARIZED CORD
This product is equipped with a polarized alternating
current line plug. This plug fits into the power outlet
only one way. If unable to insert the plug fully into the
outlet, try reversing the plug. If the plug still fails to fit,
contact an electrician to replace the obsolete outlet.
Do not attempt to alter or modify the polarized plug.
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov

ATTACHING HANDLE

NOTE: Do not turn vacuum on until assembly is
completed.
NOTE: Vacuum cleaner and handle are packed
separately and require assembly.
1. Remove handle bracket by removing two screws.
(See Figure 1)
2. Place handle onto back of the vacuum, aligning
holes with pegs. (See Figure 2)
3. Secure handle bracket and handle with two screws
previously removed. (See Figure 2)
4. Tuck the cord into the space to the left of the handle.
5. Open bag compartment to ensure a vacuum bag is
in place.
CHARGING THE BATTERY
NOTE: Charge before first use.
NOTE: Battery is partially charged out of the
box and will run for a short time.
NOTE: Battery is located on the back of the
vacuum. It can be charged while installed
on the vacuum or can be removed from the
vacuum and charged independently.
1. Insert the AC cable into the charger and plug
opposite end into a wall socket. (See Figure 3)
PAGE 2 OF 21
SAFETY CONTINUED
FOR BEST PERFORMANCE
• Keep vacuum clean and in good operating
condition.
• Change vacuum bags when they are 2/3 full
to maximize cleaning performance.
• Always use genuine vacuum bags and
replacement parts. Use of other products may
result in poor cleaning performance, potential
vacuum cleaner damage and may void vacuum
warranty. Genuine products are designed for
maximum cleaning performance.
• Store machine carefully in a dry area.
ASSEMBLY
Figure 1
OPERATION
Figure 3
Figure 2
Handle
Bracket
Handle
LED Light
Charger
AC Cable
0122 IH-9934